Features of lightning counter tester:
1. Please charge before use. In order to ensure the charging effect and prolong the service life of the battery, a special charger is required. It takes about 3-4 hours for an empty battery to be fully charged. The red light on the charger means it is charging.
2. Pull out the telescopic discharge rod appropriately according to the installation height of the counter.
3. For the specially equipped grounding wire, one end of the plug is inserted into the tail jack of the calibrator, and the other end is clamped to the ground.
4. Press the red button, turn on the high voltage for about 1 second, the indicator light will light up (slightly flashing), you can tap the connection end of the counter and the arrester lightly to test.
5. After each click, the end of the discharge rod should leave the counter. If you need to repeat the test, do not release the button, wait for 1-2 seconds when the indicator light flashes again, you can click the test again.
6. Continuous testing will cause the calibrator to heat up, please pay attention to the appropriate gap time. To reduce failures and extend battery life.
7. The output of the calibrator is divided into three levels: high, medium and low, which can be adjusted by the toggle switch on the head to adapt to test different types or brands of counters.
8. If the indicator light does not flash after pressing the button for more than 3 seconds, it means that the battery needs to be charged.
9. Do not disassemble the verifier at will. If the capacity of the battery pack is significantly reduced or the charging efficiency is too low, it needs to be replaced. Please purchase a special battery pack from our factory.
Mobile version
15388193573
